How To Clean Injector Screen Fleck 5600sxt

Nosotros've outlined the step by footstep instructions for replacing the injector set on your Fleck 5600 Metered Softener. Keep in listen that your system may non look exactly the same as the one shown, but that is OK.

Step 1 –Shut your master water off OR plough your pump billow off and and so run some h2o After the water softener (this will purge out the water and reduce the h2o pressure). If yous do NOT shut the water off before you remove the injector set up, water will leak everywhere. Put your softener in a bypass. (Located on the back of your valve)

Step 2 –Locate (correct side of valve) and remove the injector set cover (2 screws).

Fleck 5600 softener injector set — Location of Injector Set Cover on FL 5600 MS

Be conscientious Not to lose the O-ring (safety circle) that is part of the encompass. See below.

The photo on the correct is the O-band now OFF of the cover. Information technology slips around the outside of the oval. Don't remove it, just make sure that it is there when you put the cover dorsum on or y'all will have a leak.

Footstep iii –With the cover off, use your flat screwdriver to unscrew (counter clockwise) the 2 white parts of the injector set – they are stacked. They are called the injector nozzle (short and fat) and the injector pharynx (long and skinny). If your set is NOT white that is ok. Most homeowners volition accept a white ready but they can exist other colors. The aforementioned instructions will apply.

Fleck 5600 Injector Set — Injector Set shown in valve

Step iv –Clean or Supersede. If you lot are re-using the set, use a molar pick to poke out the holes on the throat and nozzle. THEY MUST Exist CLEAN! Information technology is always ameliorate to install a new set just a cleaned one volition exist okay if information technology is non scarred or damaged. Remove and clean the screen as well. Both holes must be clean. Below is what they should expect like out of the valve and make clean or new.

Step five –Screw dorsum (clockwise) in the new or cleaned pharynx (long and skinny) followed by the nozzle (short and fat). Tighten but do Not over tighten. Insert the screen in the bottom hole.

Footstep half dozen –Reattach the injector encompass with the ii long screws. Make certain the embrace still has the O-ring.

Step 7 –Plough the water and/or pump back on. Run some h2o slowly in your tub to purge out whatever air.

CONGRATULATIONS – Yous ARE DONE!

Please exist advised that we offering this data with adept intentions but you must proceed at your ain hazard. Thanks for reading!